ENGLISH
9
Fig. 6
Shelf Clip
Shelf Post
Push
Hook
2. SET UP
IMPORTANT
1. Do not tilt the unit more than 45° when
mounting the legs or casters.
2. Carry the unit by holding its bottom.
1) Cut the shipping band and remove the carton.
2) Take out the accessory legs or casters.
3) Tilt the unit backward to mount the front legs or
casters (work in pairs).
Fig. 5
Fig. 4
Carton (Base)
Carton
Shipping Band
* Avoid a site where dripping is not allowed.
Especially, a side-by-side or back-to-back
installation (possibly with other manufacturer’s unit)
may cause condensation between the two units,
resulting in dripping onto the floor.
* Do not expose the unit to direct sunlight or higher
temperatures.
* Allow at least 50 cm clearance between the
front panel air inlet/outlet and the wall or other
equipment for proper air circulation. The front of
the unit should have enough space for smooth
adjustment of the cabinet temperature. If the
ambient temperature can exceed 38°C, allow at
least 10 cm clearance from the wall at the side of
the machine compartment to prevent overloading
and damaging the refrigeration circuit.
Fig. 3
Air Outlet
Air Inlet
Min. 50cm
4) Mount the rear legs or casters in the same way.
When mounting the casters, lock the two front
casters before mounting the rear ones, or the unit
will slide when tilted.
5) Before operating the unit, remove all shipping
carton, packing, tape(s) and protective plastic film
on the exterior and top panel. Be careful not to
damage the exterior panels.
6) Position the unit in a selected site.
7) Clean the interior with a soft cloth soaked in cold
or warm water containing the proper amount of
neutral cleaner and wrung dry.
8) Level the refrigerator/freezer in both the left-to-
right and the front-to-rear directions.
3. SHELF AND RAIL
[a] SHELF, SHELF CLIP AND SHELF HOLDER
* The shelf is adjustable in 2.5 cm increments. Adjust
the shelf clips according to the height of stored
items.
* To attach the shelf clip, insert the upper tab into
an adjust hole in the shelf post to hook the shelf
clip, and push the lower tab into another adjust
hole until it locks in place. To detach the shelf clip,
reverse the above procedure.
