Hoshizaki DCM-240BAF, Руководство по обслуживанию

Страница: 24 / 48

24
a) Fan Motor
b) Timer
a) Water supply
b) Water Valve
c) Float Switch
d) Water Control Relay
e) Bin Control Switch
f) Ice Making Switch
g) Drain Cap
a) Float Switch
b) Water Control Relay
[5] Fan Motor
will not start.
[6] No water or
poor flow.
[7] Ice dispenser
will not stop
even if out of
water.
1) Replace.
2) Replace.
3) Check for loose connec-
tion or open, and replace.
4) Check and replace.
1) Check for continuity and
replace.
2) Replace.
3) Tighten.
1) Wait until water is sup-
plied, or adjust the pres-
sure range within
10-113 PSIG.
2. Open.
1) Clean.
2) Replace.
1) Replace.
2) Clean.
1) Check for continuity and
replace.
1) Replace.
1) Check for continuity and
replace.
1) Move to “ON” position.
2) Check for continuity and
replace.
1) Install.
1) Replace.
2) Clean.
1) Replace.
PROBLEM POSSIBLE CAUSE REMEDY
1) Motor winding opened.
2) Bearing worn out.
3) Wiring to Fan Motor.
4) Fan blade bound.
1) Bad contacts (X2 Relay).
2) X2 Relay coil winding
opened.
3) Loose connections.
1) Water failure or pressure too
low.
2) Shut-off Valve closed or
restricted.
1) Clogged filter.
2) Coil winding opened.
1) Contacts fused.
2) Clogged.
1) Bad Contacts (Terminal
Nos. 1 and 5).
2) Contacts fused (Terminal
Nos. 3 and 5).
1) Bad contacts.
1) “OFF” position.
2) Bad contacts.
1) Removed.
1) Contacts fused.
2) Clogged.
1) Contacts fused (Terminal
Nos. 4 and 6).
A2AAA0269806