Hoshizaki DBF-25SAC, Инструкция по эксплуатации

Страница: 32 / 36

29
ENGLISH
11) Open the beer circuit.
Rotary type: Turn the keg coupler handle clockwise until it stops.
Vertical type: Push down the keg coupler handle until it locks in place.
Note: If the cleaning tank is provided with a siphon tube, lay the cleaning tank with the ferrule at the top. If not, lay the
cleaning tank with the ferrule at the bottom.
12) Prepare a plastic bucket to receive cleaning water. Move the beer tap lever
toward you to dispense water. When beer turns into water, move the lever to
the back to flush the foam circuit.
13) When no more water comes out, turn the regulator adjust dial counterclockwise
to “0”. Leave the beer tap open. Shut off the CO2 gas cylinder by turning the
main valve clockwise. When the gas stops, move the beer tap lever back to its
original position to close the beer tap.
14) Close the beer circuit.
Rotary type: Turn the keg coupler handle
counterclockwise until it stops.
Vertical type: Unlock and lift the keg
coupler handle all the way up.
15) Turn the keg coupler counterclockwise, and remove it from the cleaning tank.
16) Attach the keg coupler on the keg by turning it clockwise until it stops.
17) Wash the cleaning tank thoroughly, dry it well, and use the cap provided to
shut out dust.
18) Wipe moisture from the beer tap nozzle. Wash the nozzle cap clean, and fit it
on the nozzle. The nozzle cap must be removed and stored in a clean place
during operation.
2. BEER TAP (DAILY)
1) Loosen the union nut of the beer tap by turning it clockwise, and remove the beer tap.
2) Tilt the beer tap lever toward you, and run tap water through the beer tap.
3) Refit the beer tap by turning the union nut counterclockwise.
Bucket
Keg Coupler Handle
Rotary Type Vertical Type
Keg Coupler Handle
Rotary Type
Vertical Type
Siphon Tube
Provided Not provided
Keg Coupler
Rotary Type Vertical Type
Cleaning Tank
Union Nut
Loosen (clockwise)
Tighten (counterclockwise)