Hoshizaki DBF-25SAC, Инструкция по эксплуатации

Страница: 30 / 36

27
ENGLISH
[b] LEADING BEER TO TAP
IMPORTANT
Frequently dump water and beer from the drain pan. The cooling water in the water tank will increase in volume by taking
moisture from the air, and come out through the overflow hose into the drain pan. If left as it is, water will flow out of the drain
pan onto the floor.
1) Check that the regulator adjust dial is set to the appropriate pressure specified by the beer company.
2) Check that the beer tap lever is closed. Opening the keg coupler with the beer tap lever open will cause beer to splash out.
3) Open the keg coupler.
4) Set a mug to receive beer, and push the beer tap lever hard to the back (foam position). Keep pushing it to dispense foam.
When the mug is half filled with foam, move the lever back to its original position to stop foam.
5) Wait for more than 1 minute after step 4) to settle beer in the circuit.
6) Set another mug, and pull the beer tap lever toward you to dispense beer. Keep dispensing beer until foam turns into liquid.
7) Check the keg coupler and keg connection and the beer hose joints for beer leaks.
[c] DISPENSING BEER
IMPORTANT
If the beer circuit is not flushed and beer is left in the beer tap, the valve shaft may jam inside the beer tap, resulting in
unavailable, unstable, or continuous dispensing actions. In this case, disassemble and clean the beer tap in accordance with “III.
5. DISASSEMBLY AND CLEANING OF BEER TAP (WEEKLY)”.
1) Tilt a clean mug at an angle of 45°, and place its inner surface in contact with the liquid nozzle of the
beer tap.
2) Pull the beer tap lever toward you to dispense beer over the inner surface
of the mug.
3) After dispensing a specific amount of beer, move the beer tap lever back to its original position to stop
beer.
4) To add foam, push the beer tap lever to the back. Foam will keep coming
out of the foam nozzle of the beer tap while the lever is pushed. To stop
foam, move the lever back to its original position.
[d] END OF OPERATION
IMPORTANT
To prevent excessive mixture of CO2 gas in draft keg beer, be sure to close the main valve of the CO2 gas cylinder at the end
of operation.
The accessory nozzle cap protects the beer tap nozzle against dust or insects while the dispenser is not used. Always cap the
nozzle at the end of operation.
When the keg coupler on the keg is closed, gas may stay inside the beer circuit. To prevent excessive foaming or improper
dispensing actions, lead beer into the beer circuit until gas comes out of the beer tap before starting operation on the following
day.