horsch Terrano 5 FM, Руководство по эксплуатации

Страница: 15 / 42

11
Operation of the hydraulic system re-
quires utmost attention. Operating er-
rors can cause damage to man and
machine.
Hydraulic connectors are marked with symbols,
to prevent operating errors.
Pressure accumulator
The hydraulic system is equipped with
a pressure accumulators.
It requires extreme care in handling
to avoid accidents.
Do not open or work (welding, drilling) on
pressure accumulators. Even when empty, the
accumulator is still preloaded by gas pressure.
Always de-pressurize the pressure accumulator
before starting work on the hydraulic system.
The pressure gauge should not indicate any
pressure.
The pressure gauge reading should drop to 0
bar. Only then may work be carried out on the
hydraulic system.
Changing implements
¾
Secure the machine against unintended roll-
ing away!
¾
Secure lifted frame parts, under which you will
be working, with suitable supports!
¾
Caution! Danger of injury caused by protrud-
ing parts (harrow, tines, share)!
¾
Do not use the packer tyres or other rotating
parts to climb onto the machine. These could
start to rotate and you could fall and be seri-
ously injured.
In operation
¾
Check the area around the machine (for chil-
dren!) before setting off and starting operation
of the machine. Ensure sufficient visibility!
¾
Do not remove any of the mandatory and
supplied protective devices.
¾
Stay clear of the operating range of hydrauli-
cally operated parts.
¾
Only use ascending aids and steps when
machine is at standstill. Passengers are not al-
lowed to ride on the machine during operation!
Service and maintenance
¾
Ensure that regular tests and inspections are
always carried out to schedule, as specified
in the operating instructions.
¾
Prior to performing maintenance and servicing
work, ensure that the machine is positioned
on firm, level ground and that it is properly
secured against rolling away.
¾
De-pressurise the hydraulic system and lower
or support the implement.
¾
After cleaning, check all hydraulic lines for
leaks and loose connections.
¾
Check for chafing and signs of other damage.
Remedy any faults immediately!
¾
Retighten screwed connections which had
been loosened during servicing and mainte-
nance work.
Do not wash new machines with a
steam-jet or high-pressure cleaner. The
paint takes approx. 3 months to cure
and could thus be damaged if this time
has not yet expired.