02/2021
Pag
e 3
LMAN0073-01-EN
Hazardous Location Series
Installa�on:
Ceiling
Step 1. Mark and drill desired loca�on on moun�ng surface.
Secure the hood with 4 (M10) expansion bolts
(not provided) directly to a structural member;
thread onto a NPT 3/4 inch conduit.
Step 2. Hang the fixture onto the hinge hook of the hood.
Connect supply wires to luminaire wire leads
(or Wago connectors provided)
Step 3. Close driver housing, making sure that all wires are
safely inside driver. Tighten three cap�ve closing
screw (M6) to (6 N-m).
Note: All installation must refer to "NPT Assembly
Instructions" to prevent water leakage.
Bracket
Step 1. Secure the bracket and hood with 4 (M10) expansion
bolts (not provided) directly to a structural member;
make sure the hinge is located as marked,
(See Figure 1a.)
Adjust the angle (6x15°) of the bracket and fix the
posi�on with M5 screws (provided).
Step 2. Hang the fixture onto the hinge hook of the hood.
Connect supply wires to luminaire wire leads (or Wago
connectors).
Step 3. Close driver housing, making sure that all wires are safely
inside driver. Tighten three cap�ve closing screw (M6) to
(6 N-m).
Note: All installation must refer to "NPT Assembly
Instructions" to prevent water leakage.
Step 1
Figure 1a
Step 2
Step 3
Step 1
Step 2
Step 3
Expansion bolts
(Washers required ) M10
3/4’’ NPT
Expansion bolts
( Washers required ) M10
Soket head cap screw M5
Soket head cap screw M10
3/4’’ NPT
Angle 0-90° Adjustable (6X15°)
