LMAN0073-01-EN
Hazardous Location Series
02/2021
Pag
e 5
Wall 90º
Step 1. Mark and drill desired loca�on on moun�ng
surface, secure the junc�on box (provided) with 4
(M8) expansion bolts (not provided) directly to a
structural member
；
thread onto a NPT 3/4 inch
conduit.
Step 2. Pull field wiring into the wall mount adapter.
Secure the adapter with 6 (M4) screws (provided)
directly to the junc�on box. Make sure the gasket
of the adapter is properly inserted into the slot.
Step 3. Hang the hood onto the adapter, align as marked.
Step 4. Rotate the hood clockwise and secure the adapter
with M5 screws (provided) to (5 N-m).
Step 5. Hang the fixture onto the hinge hook of the hood
and Connect supply wires to luminaire wire leads
(or Wago connectors).
Step 6. Close driver housing, making sure that all wires are
safely inside driver. Tighten three cap�ve closing
screw (M6) to (6 N-m).
Note: All installation must refer to "NPT Assembly
Instructions" to prevent water leakage.
Step 1
Step 2
Step 3
Step 4
Step 5
3/4’’ NPT
Expansion bolts
(Washers required) M8
Step 6
Socket head cap screws M4
Top view
Mark
Mark
Top view
Socket head cap screws M5
Step 6
