HORNER ETG-HHR, Руководство пользователя

Страница: 4 / 6

Pendant
Step 1. Thread the pendant hood onto the NPT 3/4
inch conduit. Tighten the M5 set-screw.
Step 2. Hang the fixture onto the hinge hook of the
hood. Connect supply wires to luminaire
wire leads (or Wago connectors).
Step 3. Close driver housing, making sure that all
wires are safely inside driver. Tighten three
cap�ve closing screw (M6) to (6 N-m).
Note: All installation must refer to "NPT Assembly
Instructions" to prevent water leakage.
Stanchion 25º / Stanchion 90º
Step 1. Securely thread the adapter onto the appropriate
NPT size conduit. Determine the appropriate
orienta�on and �ghten the M5 set-screw. Make
sure the gasket of the adapter is properly inserted
into the slot.
Step 2. Hang the hood onto the adapter, align as marked.
Step 3. Rotate the hood clockwise and secure the adapter
with M5 screws (provided) to (5 N-m).
Step 4. Hang the fixture onto the hinge hook of the hood,
Connect supply wires to luminaire wire leads (or
Wago connectors).
Step 5. Close driver housing, making sure that all wires are
safely inside driver. Tighten three cap�ve closing
screw (M6) to (6 N-m).
Note: All installation must refer to "NPT Assembly
Instructions" to prevent water leakage.
LMAN0073-01-EN
Hazardous Location Series
02/2021
Pag e 4
Step 1
Step 2
Step 3
Step 4
Step 1
Step 2
Step 3
Step 5
3/4’’ NPT
Socket head cap Screws M5
Step 1
Socket head cap Screws M5
Mark
Mark
Socket head cap Screws M5