Horizon Signal SQ2, Руководство пользователя, Страница: 15 / 30

WI-0055: SQ2 User Manual Version 1.0 15
Horizon Signal SQ2 User Manual
9. Enter program parameters.
Max Red: If a signal has rested in red for this amount of time, a call will be
placed to force a cycle on that phase.
Min Red: Minimum red time between green indications on the same phase.
This option prevents very short red times in the event of a detection
on the phase that just ran.
Min Green: Minimum green time, specifically when in Manual or Preemption mode.
Timeout: Communication timeout prior to fault for radio systems.
Red manual: When enabled, red time may be shortened by the operator in manual
mode. When disabled, programmed red times apply.
Preemption: Maximum time in seconds the Preemption will be active before
disabling.
Quartz sub: When enabled, system will revert to quartz timing mode in the event
of a radio communication interruption.
10. Give your program a name using the “Arrow”
buttons to move the cursor and the “Plus and
Minus” buttons to change characters. Choose the
Save option using the “Plus and Minus” buttons to
toggle “Yes” or “no” and enter by pressing the “E”
button.
11. Finally, you can choose to upload and run the
program immediately. If you choose “No”, the
program is stored in memory, but not uploaded.
Program name
Corporate Blvd_
SPECIAL
UPLOAD PROGRAM
PROGRAMMING
Upload program
“Corporate Blvd”?
Corporate Blvd
PROGRAMMING
Save program
“Corporate Blvd”?
Max. red: - - s
Min. red: 1 s
Min. green: 5 s
Timeout: 5.0 s
Red manual: Disabled
Preemption: Unlimited
Quartz sub: Disabled
PARAMETER
SPECIAL
Amount of switching
times
0
8. Enter the number of times you will switch between programs. If you only chose to
create 1 program in Step 5, this number should be 0. If you have created multiple
programs, you can choose up to 30 switch times to move between each program.
Yes
Yes