Horizon Hobby E-flite EFL87950, Инструкция по эксплуатации

Страница: 9 / 84

EN
9
The Spektrum AR8360T receiver is recommended for this airplane. If you choose to
install another receiver, ensure that it is at least a 8-channel full range receiver. Refer to
your receiver manual for correct installation and operation instructions.
Installation (AR8360T shown)
1. Mount the receiver parallel to the length of the fuselage with the servo leads
to the rear and the label facing up, as shown. Use heavy duty double-sided
servo tape.
NOTICE:
Incorrect installation of the receiver could cause a crash.
2. Attach the appropriate control surface leads to the their respective ports on
the receiver using the chart.
3. Route antennas as shown, and secure them in to place with tape.
Receiver Installation ( ARF Plus )
AR8360T Port Assignments
BIND/PROG/SRXL2 = Capacitor
1 = Throttle
2 = Left Aileron
3 = Elevator
4 = Rudder
5 = Retracts
6 = Right Aileron
7= Aux BEC
8= Afterburner Ring (optional)
Battery Installation and ESC Arming
Battery Selection
A 6S 4000-7000mAh LiPo battery is required. The Spektrum 5000mAh 22.2V 6S
50C Smart LiPo battery (SPMX56S50) is recommended. Refer to the Optional Parts
List for other recommended batteries. If using a battery other than those listed,
the battery should be within the range of capacity, dimensions and weight of the
Spektrum LiPo battery packs to fit in the fuselage. Be sure the model balances at
the recommended CG before flying.
1. Lower the throttle and throttle trim to the lowest settings. Power on the
transmitter, then wait 5 seconds.
2. Remove the battery hatch.
3. For added security, apply the loop side (soft side) of the optional hook and loop
tape to the bottom of your battery, and the hook side to the battery tray.
4. Install the fully charged battery in the center of the battery compartment as
shown. Secure using the hook and loop straps.
5. Connect the battery to the ESC. If you have not completed the bind sequence,
do so at this time as outlined in this manual.
CAUTION:
Always keep hands away from the fan intake. When armed, the
motor will turn the rotor in response to any throttle movement.
6. Keep the aircraft immobile and away from wind or the system will not initialize.
• The motor will emit a series of rising tones when the battery is connected,
and then 6 even tones indicating the number of cells connected.
• An LED will light on the receiver when it is initialized
7. Reinstall the battery hatch.
NOTE:
When using 6S batteries of 4000-5000mAh capacity, a rating of 50C or
greater is required for best performance.
ESC Tones
If the ESC sounds a continuous double beep after the flight battery is connected,
recharge or replace the battery.
ESC Error Tones Tone Meaning Possible problem
Continuous slow single tones Abnormal throttle signal
Transmitter and receiver not bound
Throttle lead damaged or not plugged into receiver
Throttle lead plugged into receiver backward
Continuous rapid single tones Throttle signal not at low position
Throttle stick not at low position
Throttle travel reduced below 100%
Throttle reversed
Throttle trim raised
Continuous double tones Battery voltage is beyond acceptable range
Verify battery is a 22.2V 6-cell LiPo
Verify battery is fully charged