Horizon Hobby E-flite EFL87950, Инструкция по эксплуатации

Страница: 5 / 84

Wing Installation
1. Slide the short wing tube (10 x 420mm) ( A ) into the front hole in the fuselage.
2. Slide the long wing tube (7.75 x 750mm) ( B ) into the rear hole in the fuselage.
3. Slide each wing on to the tubes until it fully mates with the fuselage, paying
close attention to make sure the hands free connector aligns and engages.
4. Secure the wing halves into position from the bottom using the four included
M3x20mm countersunk machine screws ( C ) (2mm hex driver required).
Disassemble in reverse order.
EN
5
A
B
Model Assembly
Horizontal Stabilizer Installation
1. Invert the fuselage and slide the stabilator rod (
A
) into the mount on the
fuselage.
IMPORTANT:
Care must be taken when inverting the fuselage.
2. Secure the stabilator rod in the fuselage with the included M3 x 10mm
countersunk machine screw (
B
) (2mm hex driver required). Tighten the screw
until the screw head reaches the countersink of the fuselage.
3. Ensure the screw captures the groove on the stabilator rod.
4. Insert the Z-bend into the 3rd hole from the output shaft of the servo arm. The
pushrod should be inserted from the outside of the arm and then snap the ball
link onto the ball mounted on the control horn.
5. Repeat the process for the other stabilizer half.
A
E
A
R
M3 x 10mm (2)
Machine Screw
B
M3 x 20mm (4)
Machine Screw
C