COM0 / COM1 S
ERIAL
I
NTERFACES
48 / 98
6842 GPS Slim Line System - V09.01
hopf
Elektronik GmbH
Nottebohmstr. 41 • D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
After entering the final figure for the baud rate the following message appears on the display:
Input frame:
B :
0 9 6 0 0
W : _
The number of data bits for the transmission must be given here. Possible settings are:
•
8
for 8 data bits
•
7
for 7 data bits
After entering the figure for the number of data bits the following message appears on the
display:
Input frame:
B :
0 9 6 0 0
W :
8
P : _
The type of the parity bit for the transmission must be given here. Possible settings are:
•
N
for no parity bit
•
E
for even parity
•
0 (zero)
for odd parity
After entering the parity function the following message appears on the display:
Input frame:
B :
0 9 6 0 0
W :
8
P :
N
S : _
The number of stop bits for the transmission must be selected here:
•
1
for 1 stop bit
•
2
for 2 stop bits
Finally the enabling of the handshake lines RTS and CTS appears.
Input frame:
B :
0 9 6 0 0
W :
8
P :
N
S :
1
H S : _
The following can be entered here:
•
N Data
transmission
without
handshake
Õ
Setpoint for this equipment version
•
Y Data
transmission
with
handshake
No handshake lines are available in this version of the device.
Data transmission
without handshake
must
be activated in order for the
serial interfaces to function correctly.
The
ENTER
key must be activated after the final entry.
By doing so a plausibility check of
the complete data entry is undertaken. If the data entry is valid the new settings are
transferred.
