– 25 –
How to Display Faults (Zones)
If the system shows the “Not Ready Fault” message, it means a zone or zones
are open (faulted). Zones must be closed or bypassed before you can arm the
system.
Distressed Zones Buttons
Alarm
Trouble
Fault
LOBAT
Bypass
All
To display the open zone(s), do the following:
1. Select
Security
, then click the
SHOW ZONES
button.
2. Click the
DISTRESSED ZONES
button, and then click the
FAULT
button.
A listing of faulted zones is displayed. As applicable, take corrective action
such as closing a window or door to correct the fault.
3. If the fault cannot be corrected, you may choose to bypass the zone. by
selecting the zone then click the
BYPASS
button. Refer to the How to
Bypass Zones section for more details on bypassing zones.
How to Bypass Zones
The Bypass function is used when you want to arm your system with one or
more zones left open. Bypassed zones are unprotected and do not cause an
alarm when violated while your system is armed.
•
Some systems do not allow you to bypass fire, carbon monoxide or
emergency zones. On certain fire control systems, a specified user may be
allowed to bypass fire, carbon monoxide and system zones if the user was
enabled by your system installer.
•
Limits apply as to how many zones can be bypassed at one time. See your
installer for these limits.
Show Zones Buttons
Show Zones
Clear
Refresh Data
Bypass
Selected
Distressed Zones
1. Select
SECURITY
.
2. Click the
SHOW ZONES
button.
3. Choose the zone(s) to be bypassed and click the
BYPASS SELECTED
button.
4. Enter your 4-digit user code.