– 20 –
Door
Choose the door status at which the action begins:
•
Locked
(action starts when the door is locked)
•
Unlocked
(action starts when the door is unlocked)
•
Code Unlocked
(action starts when door is unlocked
by manual code entry)
Zones
Choose the zone condition to cause the action to begin:
•
Restore
(for trigger only; not for use with conditions)
•
Alarm
(upon an alarm from a specific zone or zones)
•
Fault
(upon a fault from a specific zone or zones)
Garage
Door
Choose the doors condition to cause the action to begin:
•
Opened (action starts when door the status of the
door changes to open)
•
Closed (action starts when door status of the door
changes to close)
Water
Valve
Choose the valves condition to cause the action to
begin:
•
Opened (action starts when valve opening is
finished.)
•
Closed (action starts when valve closing is finished)
Condition
Defines an optional event that adds a condition to the trigger.
If a condition is set, the condition must exist at the time of the
trigger in order for the action to occur. Conditions include the
same categories as triggers, however, conditions cannot be set
with the same category as the trigger. (ex., if setting a trigger
event for security, you cannot use a security event as a
condition).
Action
Defines the desired device action(s) when the trigger event
occurs. Actions include the following categories:
Security
Choose the mode to occur upon the trigger event:
Disarm
Away
Stay
Night (arms
Instant)
Enter User
Code
NOTE:
A valid user code is required
for the system to perform any of the
actions listed. Enter the code at the
prompt. If the user code is later
deleted from the security system,
you will need to reenter a valid code
at this screen.
Thermostat
Choose the action to occur upon the trigger event:
Off
Heat
Cool
Set point
Set energy mode (normal/savings); if savings selected,
see your local programming of the thermostat for
settings