Honeywell StratosH MS2320, Инструкция по установке и эксплуатации

Страница: 43 / 76

37
S
CANNER
O
PERATION
S
TARTUP
When the scanner
first receives power the white LED will flash, the blue LED will turn on and the scanner will beep once
( the white LED will remain on for the duration of the beep ). The scanner is now ready to scan.
P
OWER
-U
P
T
EST
M
ODE
When a Stratos
H scanner is first powered up, it cycles through a number of self-tests before starting normal operation. If there are any
initial failures during this sequence of tests the scanner will beep or razz to indicate the error and an error code will appear in the
diagnostic indicator display.
The following are examples of the types of tests performed at power-up.
1. Memory
tests
2. Hardware setup tests
3. Motor
tests
4. Laser tests
5. Configuration tests
6. Interface tests
7. Scale tests
These tests are also performed on a periodic basis with the operator alerted to any failures.
C
ONFIGURATION
M
ODE
All Stratos
H series scanners have been configured at the factory with a set of default communication protocols. Since many host
systems have unique formats and protocol requirements, Honeywell provides a wide range of configurable features that may be
selected with the use of the MetroSelect
®
Configuration Guide (
PN
00-02407
x
), the MS2
x
20 Stratos Series Scanner/Diva Scale
Configuration Addendum (
PN
00-02272
x
) and MetroSet.
For a complete list of the factory default settings, refer to the
Default Settings section of this guide.