page 8 of 24
These are recommendations. If it is secured, that the cable will not
touch the steel structure, the maximum distance between the
intermediates can be used.
B6.
At least the following components must be used when installing the
Söll Vi-Go system:
1. Cable tensioner (2)
2. Cable 7 x 19 (8 mm / 10 mm / 3/8“) (3)
B7.
Installing the Söll Vi-Go system:
1. Fasten the steel Cable (3) at the upper attachment point.
2. Install the cable tensioner (2) at the lower attachment point.
Fig. B2
A: Tensioning element
B: Tension reading
C: Rope attachment point
D: Lock nuts
3. Hang the cable (3) at the cable attachment point (C) of the cable
tensioner (2).
4. Turn the tensioning element (A) counter clockwise until the
tension reading (B) is between the minimum and the maximum
marking. At 500 N the cable is sufficiently pre-tensioned.
5. Secure the tensioning element (A) against twisting using the two
locking nuts (D).
B8.
Note
The cable of the
Vi-Go
system must be pre-tensioned to ensure the
correct functioning of the shuttle. The required pre-tension is 500 N
(+/- 100 N).
