HW3000/HW3000L Portable Electrical Generator Owner’s Manual
www.honeywellgenerators.com
7
Assembly
Step 1: Install Support Legs
1.
Place the generator on a flat, level surface.
2.
Stand at side of generator
opposite
recoil starter
handle. Grip frame; carefully pull up and push to tilt
generator backward.
3.
Gently set generator onto the recoil side or elevate
the generator by placing solid wood pieces under-
neath generator.
4.
Attach rubber stoppers to the bottom of the support
leg using 25 mm long full-thread hex flange bolts and
M10 serrated flange nuts; tighten until securely
seated.
5.
Attach each support leg to pre-drilled holes on bottom
of generator frame, using 16 mm long full-thread hex
flange bolts and M13 serrated flange nuts; tighten
until securely seated.
To install support legs, you will need:
M8 x 25 mm long full-thread hex flange bolts (2)
M10 serrated flange nuts (2)
M10 x 16 mm long full-thread hex flange bolts (2)
M13 serrated flange nuts (2)
Bracket (1)
Rubber stoppers (2)
Socket wrench with 10 mm socket
*
*
Not included
Generator must be empty of engine oil and fuel.
Drain engine oil and fuel, if necessary.
Generator is heavy! Lifting generator can cause
back or other bodily injury. NEVER lift generator
without assistance.
FIGURE 5:
Tip onto Generator Recoil Side
CAUTION
FIGURE 6:
Rubber Stoppers Attached to Support Leg
FIGURE 7:
Support Leg Attached to Generator
Содержание HW3000
Страница 87: ... ...