HW3000/HW3000L Portable Electrical Generator Owner’s Manual
www.honeywellgenerators.com
9
Assembly
Step 3: Install Handle Assembly
1.
Slide rubber handle grip onto each handle bar and tap
on hard surface until fully seated.
2.
Hold handle pivot bracket over pre-drilled holes on
frame as shown in Figure 12.
3.
Attach bracket to frame using 40 mm long full-thread
hex flange bolts and serrated flange nuts and tighten.
4.
Confirm the handle bar is securely fastened to the
bracket as it may have loosened during shipping.
•
To collapse handles
, push in the locking pin and
adjust the handle downward until it rests vertically
against the generator frame.
•
To return handles to horizontal position
, push in
the locking pin and pull up on handle until the locking
pins lock in place.
To install handle assembly, you will need:
Handle bars with brackets (2)
Rubber handle grips (2)
M8 X 40 mm long full-thread hex flange bolts (4)
M10 serrated flange nuts (4)
Socket wrench with 8 mm socket
*
*
Not included
10 mm open end wrench*
FIGURE 11:
Attach Grips to Handle
FIGURE 12:
Handle Bracket to Frame
FIGURE 13:
Tighten Handle Bar Bolt
Hands and fingers can be pinched from collapsible
handles.
• Keep hands and fingers clear from hinges when
collapsing generator handles.
• Handles should only be used to roll the generator to a
new location. If lifting the generator (i.e. into a vehicle),
never use the handles to support the complete weight
of the generator.
CAUTION
Содержание HW3000
Страница 87: ... ...