Honeywell HTR62, Инструкция по установке и эксплуатации

Страница: 19 / 46

HTR62 Installation and Operating Guide
Rev 1.01 7 Document 900.0341
12/05
To connect the wiring harness:
1. Plug the DB25 connector on the HTR62 wiring harness into the back of the VCR (see
Figure 2-2 ) and tighten the retaining screws.
2. Remove the 3A fuse from the fuse holder.
3. Connect the fuse holder and power harness to the vehicle main battery power and
ground points. If a master power switch (kill switch) is used in the vehicle, attach the
power harness after the switch.
4. Connect the signal harness to the ignition switch and input signals at the fuse box or
under the dash.
The connection to the ignition switch starts and stops the VCR; it does not power the
VCR. If possible, connect this wire to the radio accessory fuse to avoid electrical
interference from fans or blowers.
5. Connect the speed sensor harness to the vehicle speed sensor, if desired. See
page 20 for calibration programming. Refer to the vehicle wiring guide for correct
location of wires.
6. Connect the Video and Audio connectors from Camera 1 into Cam 1 Video and Main
Audio respectively.
7. If a second camera (for example, Stop Arm) is used, connect it to Cam 2 Power and
Cam 2 Video.
8. An optional external microphone can also be connected to the Aux In Audio. To order,
contact your Honeywell representative. See the back cover of this guide for contact
information.
9. Insert the 3A fuse into the fuse holder connected to the positive battery terminal of the
vehicle.
Figure 2-2 shows the wiring on the wiring harness that connects to the electrical system.