Honeywell HTR62, Инструкция по установке и эксплуатации

Страница: 18 / 46

Rev 1.01 6 Document 900.0341
12/05
Installation
Figure 2-1 Mounting Options
Mounting the VCR Enclosure Base
To mount the VCR enclosure base:
1. Unlock the access panel in the front of the VCR enclosure cover, using one of the
keys included with the enclosure.
2. Slide the cover forward and lift it off the enclosure base.
3. Use the VCR enclosure base as a template to mark and drill pilot holes for the four
#10 x 3/4 in. sheet metal mounting screws (included with the hardware package).
Note If desired, you can drill alternate mounting holes in the VCR enclosure base.
Locate the mounting holes as close as possible to the outside edges of the
enclosure base. Ensure that the mounting fasteners do not touch the VCR
when it is installed.
4. Attach the VCR enclosure base to the mounting surface, using the four #10 x 3/4 in.
sheet metal mounting screws.
Wiring
Figure 2-2 shows the wiring harness and camera harness that connects into the back panel
of the VCR.
Note Start cabling at the VCR to ensure that the DB25 connector has sufficient
length to reach the VCR.
Horizontal options
Inverted Installation Upright Installation