Honeywell HTR62, Инструкция по установке и эксплуатации

Страница: 27 / 46

HTR62 Installation and Operating Guide
Rev 1.01 15 Document 900.0341
12/05
Programming the VCR
The display parameters, date and time, speedometer calibration, and power control
settings must be programmed into the VCR. The alphanumeric information displays on
three lines at the top or bottom of the image on the screen (user selectable).
Note The programmed settings are retained in the VCR even if the HTR62 is
disconnected from the vehicle battery.
To program the VCR:
1. Unlock the access panel on the front of the VCR enclosure and remove the enclosure
cover.
2. Plug an RCA cable into the VIDEO OUT jack in the front panel of the VCR. Plug the
other end into the VIDEO IN jack of a portable monitor.
STOP Use this button to:
• Enter Program mode. Press and hold
the button for three seconds to
display the Setup screen.
• Exit Program mode. Press and hold
for three seconds. Your configuration
settings are saved when you exit
Program mode.
Note The VCR automatically exits
Program mode if no button is
pressed in 60 seconds.
Stops the current VCR operation or stops
image playback.
If the ignition trigger is on, the VCR
automatically starts recording.
SLOW (
❘
) Resumes normal playback speed.
AUDIO Selects audio playback function.
A/V Not currently available.
TCOUNTER Displays tape timer
A REPEAT Not currently available.
REC Not currently available. You can change the
recording speed in Menu mode (see
Lines 5
and 6 , page 20 ).
SPEED Not currently available.
Table 3-1 Remote Control Button Functions
Control Program mode function Play mode function