Honeywell HTR62, Инструкция по установке и эксплуатации

Страница: 28 / 46

Rev 1.01 16 Document 900.0341
12/05
System Setup
3. Start the vehicle. The VCR automatically starts recording after approximately 10
seconds, subject to Record Delay and Timer settings. You should see the
alphanumeric display superimposed on the video image from the camera.
4. Press the STOP button once to stop the VCR recording. OR press and hold for three
seconds to enter Program mode.
For a short programming session, you may press the POWER button (temporary
power feature) to avoid starting the vehicle.
Note You can program the VCR when no video camera is connected to the system.
In this case the message
NO VIDEO DETECTED
displays on the screen.
Figure 3-2 Welcome Screen
Initial Setup
The HTR62 comes pre-configured from the factory with the default settings shown in
Figure 3-3 . You can change the settings shown in Table 3-2 .
Honeywell
HTR62
Mobile Video Recorder
Firmware Ver 02.00
Honeywell Video Systems
For Technical Support
Call 1-800-796-2288
Table 3-2 System Default Settings
Setting To program, see section …
Title line Line 1 , page 18
Date and time, Daylight
Saving Time Line 2 , page 18
Signal indicators (T1 to T5) Lines 3 and 4 , page 19
Start Delay (SDLY) SDLY Start Delay , page 20
Recording speed (EP/SP) Lines 5 and 6 , page 20