2.4 HD6 RUGGED DOME HOUSING , CONTINUED
7. Mount the housing to a ceiling support structure or wall support structure.
The installer supplies the mounting hardware. There are four sets of mounting
holes.
.300
TYP.
1. 150
1. 150
.437
TYP.
.313
TYP.
3. 500
6. 500
2. 625
1. 930
1. 000
2. 625
3. 500
Figure 6: Mounting Bracket Hole Detail
a. The mounting bracket can be positioned between 0
°
-45
°
or 45
°
-90
°
depending
on the orientation of the mounting bracket on the housing. To change the
orientation of the bracket, remove the four nuts, lock washers and bolts that
secure the bracket to the housing. Flip the bracket over and secure the bracket
to the housing using the four nuts, lock washers, and bolts.
b. The mounting bracket can be repositioned by loosening the four nuts (two on
each side) inside the housing and sliding the bracket along the slot. Tighten the
four nuts to secure the bracket at the desired angle.
c. Secure the mount to the wall or ceiling using the appropriate hardware for the
mounting surface.
NOTE
: The mounting bracket can be at any angle from 0° to 90° with respect to the
housing.
The housing must be positioned horizontal and parallel with the floor.
Rev. 1.02
12
900.0696
1-Aug-06
Содержание HD6 Series
