Honeywell HD6 Series, Руководство по установке

Страница: 13 / 56

SECTION 2:
BASIC INSTALLATION
2.1 DROPPED CEILING HOUSING
WARNING: Installation must be performed by qualified technical
personnel and must be in accordance with all national and local
mechanical and electrical codes.
Perform the following steps to install a dropped ceiling housing . Refer to Figure 1
HOUSING
LOWER DOME
MOUNTING POSTS
(3 PLACES)
ATTACH LANYARD TO BOTTOM
TURN SCREW CLOCKWISE TO
EXTEND SUPPORT CLAMPS AND
SECURE DOME TO CEILING
(TYPICAL 3 PLACES)
WING TAB (3 PLACES)
CABLE CLAMP
SAFETY CABLE TIE POINT
(METAL TAB WITH HOLE ON SIDE OF CAN)
CONNECT SECURELY TO BUILDING
SUPPORT STRUCTURE
DROPPED CEILING PLATE
SPRING LATCH
(RELEASES TOP PLATE)
SCAN ALIGNMENT STUDS
CUSTOMER 2 FT
SPAN DROPPED
CEILING GRID
SUPPORTS
.62 (15.7) DROPPED
CEILING TILE
CUT-OUT IN CEILING TILE
7 5/8” DIA.
(193.8)
APPROX 5.00
(127)
Figure 1: Dropped Ceiling Housing Installation
1. Select the location(s) of the housing (s). Each HD6 requires a 24Vac ± 10% power
source when measured at the dome. Ensure a 24Vac @ 1.1A power source is
available at the dome. Refer to Section 3.1.1 for maximum wiring distances to the
dome.
2. Remove the ceiling panel (2’x4’ or 2’x2’) at the dome location.
3. Place the ceiling tile on the dropped ceiling plate. Trim the ceiling tile so you can
press the ceiling tile into the dropped ceiling plate.
4. Cut a hole in the ceiling tile flush with the hole in the center of the plate.
5. Secure a safety cable (supplied by installer) to a building support structure.
Honeywell Video Systems recommends using 3/32” plastic coated aircraft cable
(part 849518-0311) and looping sleeves (part 849511-0057). These parts can be
ordered from the Honeywell Video Systems parts department.
Rev. 1.02 3 900.0696
1-Aug-06