Honeywell H2W2PC1M, Руководство по настройке

Страница: 64 / 140

Performance Series IP Camera Software Configuration Guide
50
Snapshot
When enabled, the system attaches a snapshot to an email alert when an
alarm occurs.
Configuring Scene Change Settings
Go to
Setup

Video Analytics

Video Detection

Scene Change
.
Figure 7-5 Scene Change
Table 7-3 Scene Change Configurations
Parameter Function
Enable Check to enable scene change.
Alarm
Period
The camera scene change function is activated during the specified period.
See
Configuring the Alarm Period on page 47 .
You can configure up to six periods per day. Select a date. If you do not
select a date, the current setup will be applied to today only. You can
select All to apply the alarm period to the whole week.
Click OK to save the changes. The system goes back to the scene change
interface. Click Save to exit.
Record If Record is enabled, a scene change event can activate recording.
Record
Delay
The system will wait for the specified time before it begins recording. Select
from 10s to 300s .
Send
Email
When enabled, the system sends an email alert when an alarm occurs.
Snapshot
When enabled, the system attaches a snapshot to an email alert when an
alarm occurs.