Honeywell CORE Drive, Быстрый старт

Страница: 22 / 24

HONEYWELL CORE DRIVE
62-0410—04 22
cF1 EEPROM
write Err Internal EEPROM can not be programmed. 1. Press “RESET” key to the factory setting
2. Return to the factory.
cF2 EEPROM
read Err Internal EEPROM can not be read. 1. Press “RESET” key to the factory setting
2. Return to the factory.
cd1 las sensor
Err U-phase error Reboots the power. If fault code is still displayed on the keypad
please return to the factory
cd2 lbs sensor
Err V-phase error Reboots the power. If fault code is still displayed on the keypad
please return to the factory
cd3 lcs sensor
Err W-phase error Reboots the power. If fault code is still displayed on the keypad
please return to the factory
AFE PID Fbk
error PID loss (ACI) 1. Check the wiring of the PID feedback
2. Check the PID parameters settings
ACE ACI loss ACI loss 1. Check the ACI wiring
2. Check if the ACI signal is less than 4mA
EF External
fault
External Fault 1. Input EF (N.O.) on external terminal is closed to GND. Output
U, V, W will be turned off.
2. Give RESET command after fault has been cleared.
EF1 Emergency
stop
Emergency stop 1. When the multi-function input terminals MI1 to MI6 are set to
emergency stop, the AC motor drive stops output U, V, W and
the motor coasts to stop.
2. Press RESET after fault has been cleared.
bb Base block External Base Block 1. When the external input terminal (B.B) is active, the AC
motor drive output will be turned off.
2. Deactivate the external input terminal (B.B) to operate the AC
motor drive again.
Pcod Password
error
Password is locked. Keypad will be locked. Cycle power OFF and then ON to re-
enter the correct password. See Pr.00-07 and 00-08.
ccod SW Code
Error Software code error
CE1 PC Err
command
Illegal function code Check if the function code is correct (function code must be 03,
06, 10, 63)
CE2 PC Err
address
Illegal data address (00H to 254H)
Check if the communication address is correct
CE3 PC Err data Illegal data value Check if the data value exceeds max./min. value
CE4 PC slave
fault
Data is written to read-only address
Check if the communication address is correct
CE10 PC time out Modbus transmission time-out
CP10 Keypad time
out Keypad transmission time-out
dEb Dec Energy
back
When Pr07-12 is not set to 0 and momentary
power off or power cut, it will display dEb
during accel./decel. stop. 1. Set Pr07-12 to 0
2. Check if input power is stable
S1 S1-emergy
stop Emergency stop for external safety
Fire On Fire Fire Mode
Uoc,
Voc,
Woc A, B, or C
phase short
Phase A, B, or C short circuit
OPHL U, V, or W
phase
lacked Output phase loss (Phase U), (Phase V), (phase W)
Table 14. Fault Codes and Descriptions
NOTE: Additional details and screen shots of the error messages can be found in the full manual.