Honeywell AlarmNet GSMHS, Инструкция по установке и настройке

Страница: 30 / 56

GSMHS Installation and Setup Guide
3-16
PROMPTS
ZONE
TRIG.
4204/
2-4204
ENTRY OPTIONS DESCRIPTION
53
Restore Zn6 Y/N
(Y)_
 
[Y], [N] Enables restore reporting for zone 6.
UL: Must be set to “Y.”
54
Delay Zn6 (secs)
(00)_
 
[01-15]
[00] = no
delay Defines the reporting delay in seconds for
zone 6.
UL: Must be set to “00.”
55
Rpt Zn6 ONLY if
Armed (N)_
 
[Y], [N]
Reports alarms on zone 6 ONLY if the
conditional zone (zone 7 in zone trigger mode;
zone 4 in 4204 mode; zone 8 in 2-4204 mode) is
triggered (armed).
If [N], always reports alarms on zone 6.
56
Enable Zn7 Y/N
(N)_
4204
only
[Y], [N]
Enables alarm reporting for zone 7, if used.
If [N], skip to Prompt 64: "Review."
57
Zn7 Trigger Type
(V+)_
 4204
only
 (EOLR)
 (V+)
 (V–)
Selects the triggering method for this zone
input.
Press the [space] key to scroll through choices.
58
Invert Zn7 Y/N
(N)_
 4204
only
[Y], [N] Inverts the alarm and normal states of the
zone 7 trigger; otherwise uses normal input
signal.
59
Restore Zn7 Y/N
(Y)_
 
[Y], [N]
Enables restore reporting for zone 7.
Zone Trigger mode: This question will only
be displayed if zone 7 is not used as the
conditional (arming) trigger zone.
UL: Must be set to “Y.”
60
Delay Zn7 (secs)
(00)_
 
[01-15]
[00] = no
delay Defines the reporting delay in seconds for
zone 7.
Zone Trigger mode: This question will only
be displayed if zone 7 is not used as the
conditional (arming) trigger zone.
UL: Must be set to “00.”
61 Rpt Zn7 ONLY if
Armed (N)_

[Y], [N]
Reports alarms on zone 7 ONLY if the
conditional zone (zone 4 in 4204 mode; zone 8
in 2-4204 mode) is triggered (armed).
If [N], always reports alarms on zone 7.
2-4204 mode: If any zone is programmed to
"Report Only if Armed," or if tamper is
enabled, skip to "Review."
62 Restore Zn8 Y/N
(Y)_
2-
4204
only
[Y], [N] Enables restore reporting for zone 8.
UL: Must be set to “Y.”
63 Delay Zn8 (secs)
(00)_
2-
4204
only
[01-15]
[00] = no
delay
Defines the reporting delay in seconds for
zone 8.
UL: Must be set to “00.”