7845GSM/7845GSMCN Installation and Setup Guide
3-2
Using a 7720P Programming Tool
Connect the 7720P Programming Tool as shown below. The 7845GSM powers the 7720P
Programming Tool via the programming jack, and automatically senses the presence of the
7720P when it is plugged in.
TB1
7720P
PROGRAMMING
JACK
7845GSM-005-V1
A
B
C
D
E
F
S
T
X
1
2
3
4
5
6
9
8
7
#
0
Xmit
Shift
Space
Enter
Shift
N / Y
BS / ESC
/
7720 PROGRAMMING TOOL
LEDs
INTERNAL
ANTENNA
MODE AND STATUS
INDICATOR SWITCH
J1
BATTERY
CONNECTOR
TAMPER
SWITCH
R
S
S
I
M
0
M
1
G
P
R
S
IB
S
RSSI / MODE AND
STATUS LEDs
Figure 10. Cable Connections
Each key of the 7720P has two possible functions: a normal function and a Shift function.
To perform a normal key function, simply press the desired key.
To perform a Shift function, press the [shift] key, and then press the appropriate key.
The prompts in this document reflect use of the 7720P Programming Tool.
Table 2
below lists
each normal and shift key function.
Table 2. 7720P Normal and Shift Key (shift LED lit) Functions
KEY
NORMAL KEY FUNCTION
SHIFT KEY FUNCTION
BS/ESC
[BS]: Press to delete entry
[ESC]: Press to quit program mode; also can reset
programming defaults*
↓
/
↑
[
↓
]: Scroll down programming
[
↑
]: Scroll up programming
N/Y
[N]: Press for "NO" answer
[Y]: Press SHIFT-Y for "YES" answer
SHIFT
Press before pressing a SHIFT key function. Will light SHIFT LED. LED goes out once a key
is pressed. Press again for each SHIFT function desired.
1/A
[1]: For entering the number 1
[A]: For entering letter A
2/B
[2]: For entering the number 2
[B]: For entering letter B
3/C
[3]: For entering the number 3
[C]: For entering letter C
4/D
[4]: For entering the number 4
[D]: For entering letter D
5/E
[5]: For entering the number 5
[E]: For entering letter E
6/F
[6]: For entering the number 6
[F]: For entering letter F
7/S
[7]: For entering the number 7
[S]: For entering letter S
8/T
[8]: For entering the number 8
[T]: For entering letter T
9/X
[9]: For entering the number 9
[X]: For entering letter X
SPACE
[SPACE]: For scrolling option list
No SHIFT function
0
[0]: For entering the number 0
No SHIFT function
#/ENTER
[#/ENTER]: Starts programming mode;
Press to accept entries
No SHIFT function
*Active only when the "Exit Programming Mode" prompt is displayed.
Using the Control Panel Programming Mode
Some control panels support programming of the 7845GSM through the control panel
programming mode (e.g., Vista-128BP). If programming through the control panel, only
the ECP Mode programming options are available. The "mode" questions will not be
displayed, and the mode cannot be changed. For a description of key functions on the
WWW.DIYALARMFORUM.COM
WWW.DIYALARMFORUM.COM