Honeywell 60 Series, Руководство по настройке

Страница: 86 / 93

Honeywell 60 Series IP Camera Software Configuration Guide
72
Figure 8-5 Access List
General Settings
Concurrent user number : Simultaneous live viewing for 1~10 clients (including main stream
to third stream). The default value is 10.
Filter
Enable access list filtering : Check this item and click SAVE to enable the access list filtering
function.
Filter type : Select Allow or Deny as the filter type. If you choose Allow Type, only those clients
whose IP addresses are on the Access List below can access the camera, and the others
cannot. On the contrary, if you choose Deny Type, those clients whose IP addresses are on the
Access List below will not be allowed to access the camera, and the others can.
Click ADD and you can add a rule to the following Access List.
Single : This rule allows the user to add an IP address to the Allowed/Denied list.
Network : This rule allows the user to assign a network address and corresponding subnet
mask to the Allow/Deny List. The address and network mask are written in CIDR format.
Range : This rule allows the user to assign a range of IP addresses to the Allow/Deny List.
Note
•
The IPv6 access list column will not be displayed unless
you enable IPv6 on the Network page. For more
information about IPv6 Settings, see
Enable IPv6 on page
34 .
•
The Range rule only applies to IPv4 addresses.