Honeywell Home Ademco Vista Series, Руководство пользователя

Страница: 28 / 64

24
Macro Key Programming and Usage (Continued)
The keypad beeps to acknowledge your input and displays the command you entered
(followed by “F”).
4. Enter the next command, followed by press/holding the “D” key for at least two
seconds. The keypad beeps and displays the keystrokes entered so far.
5. Repeat until all the desired commands (up to 16 characters including the “F”s) have
been entered .
Be sure to check your keystrokes before continuing. If you made a mistake, you must
start over.
6. To exit, press/hold the “D” key for at least two seconds. The display returns to system
status and indicates system is ready.
Example of Macro Programming
Suppose you want to (1) bypass the two upstairs window
zones, then (2) turn on an exterior light, and then (3) arm the
security system in the AWAY mode. The procedures in the
table that follows show you how you would program this
macro:
Typical Macro Alpha Display:
MACRO PGM
602F603F#701F2F
Function Keystrokes Required Keypad Display
1. Bypass zones 02 & 03 Press BYPASS [6] key, then 2-digit zone
number 02, then terminator “D”’ then [6],
then 2-digit zone number 03, then
terminator “D”.
6 0 2 F 6 0 3
2. Insert terminator Press the “D” key for at least 2 seconds.
6 0 2 F 6 0 3 F
3. Turn light on
(device 01)
Press [#] and 7 key for “device ON”, and
[01] key for selecting device 1.
6 0 2 F 6 0 3 F # 7 0 1
4. Insert terminator Press the “D” key for at least 2 seconds.
6 0 2 F 6 0 3 F # 7 0 1
F
5. Arm system AWAY Press AWAY [2] key.
6 0 2 F 6 0 3 F
#
7 0 1
F 2
6. Insert terminator Press the “D” key for at least 2 seconds.
6 0 2 F 6 0 3 F # 7 0 1 F
2 F
7. Exit Macro Mode Press the “D” key again
Using a Programmed Macro Key
∗∗∗∗ DISARMED ∗∗∗∗
READY TO ARM
1. Press the Macro key programmed for the desired
series of commands for at least 2 seconds. The “Enter
User Code” prompt appears. The prompt remains
displayed for up to 30 seconds.
ENTER USER CODE
∗ ∗ ∗ ∗
2. Enter your 4-digit security code.
The programmed macro sequence begins
automatically after the user code is entered.