Honda XL125LK, Руководство пользователя, Страница: 81 / 243

6-8
dummyhead dummyhead
FUEL SYSTEM
Remove the air cut-off valve cover [1], spring [2],
diaphragm [3] and O-ring [4].
Check the following:
– Diaphragm for pin holes, deterioration or damage
– O-ring for damage
– Spring for deterioration
– Needle of diaphragm for wear
– Air passages for clogging
Installation is in the reverse order of removal.
• Be sure that the diaphragm and O-ring do not
interfere with the cover.
FLOAT LEVEL INSPECTION
With the float valve seated and the float arm just
touching the valve, measure the float level with the
special tool as shown.
The float cannot be adjusted.
Replace the float assembly if the float level is beyond
the specified limit.
INSTALLATION
CARBURETOR BODY
Install a new O-ring [1] into the groove of the carburetor
body.
Install the carburetor [1] to the carburetor connecting
boot.
Install the carburetor mounting nuts [2] with the wire
clamp [3], then tighten the nuts securely.
Tighten the air cleaner connecting boot band screw [4].
TORQUE: 2.1 N·m (0.2 kgf·m, 1.5 lbf·ft)
[4]
[3]
[2] [1]
FLOAT LEVEL: 14 mm (0.6 in)
TOOL:
[1] Carburetor float level gauge
07401-0010000
[1]
[1]
[2]
[4]
[3]
[2]
[1]