Honda XL125LK, Руководство пользователя, Страница: 49 / 243

3-8
dummyhead dummyhead
MAINTENANCE
ENGINE OIL CENTRIFUGAL FILTER
Remove the right crankcase cover (page 10-4).
Remove the following:
– Screws [1]
– Oil filter rotor cover [2]
– Gasket [3]
Clean the oil filter rotor cover and inside of the oil filter
rotor using a clean lint-free cloth.
Remove the clip [1] while holding the oil through [2].
Remove the oil through and spring [3].
Blow compressed air through the oil through hole and
the rotor cover [4] to clean them.
Apply engine oil to the oil through sliding area.
Install the spring and oil through, and secure it with the
clip.
Check that the oil through operates freely, without
binding.
Install the rotor cover [1] with a new gasket [2] and
tighten the three screws.
Install the right crankcase cover (page 10-4).
ENGINE IDLE SPEED
• Inspect and adjust the idle speed after all other
engine maintenance items have been performed
and are within specifications.
• Engine must be warm for accurate adjustment. Ten
minutes of stop-and-go riding is sufficient.
Warm the engine, shift the transmission into neutral and
support the motorcycle upright on a level surface.
Connect a tachometer and check the idle speed.
If the adjustment is necessary, turn the throttle stop
screw [1] as required.
[1]
[2]
[3]
[4]
[3]
[2]
[1]
TORQUE: 4.0 N·m (0.4 kgf·m, 3.0 lbf·ft)
[1]
[2]
IDLE SPEED: 1,500 ± 100 min
-1
(rpm)
[1]