Honda XL125LK, Руководство пользователя, Страница: 72 / 243

5-7
dummyhead dummyhead
ELECTRIC STARTER
STARTER RELAY
REMOVAL/INSTALLATION
Disconnect the negative (–) cable from the battery
(page 17-5).
Disconnect the starter relay switch 4P (Red) connector
[1].
Remove the nuts [2], battery cable [3] and starter motor
cable [4] from the starter relay switch [5].
Remove the starter relay switch from the stays of the air
cleaner housing.
OPERATION INSPECTION
Remove the left side cover (page 2-2).
Shift the transmission into neutral.
Turn the ignition switch to "ON" and push the starter
switch.
The coil is normal if the starter relay switch [1] clicks.
If you don't hear the switch click, inspect the relay
switch circuits (page 5-7).
CIRCUIT INSPECTION
Remove the left side cover (page 2-2).
Inspect the starter relay circuit as follows:
GROUND LINE
Turn the ignition switch to "OFF".
Disconnect the starter relay switch 4P (Red) connector
[1].
Check for continuity between the Green/red wire
terminal of the wire harness side connector and ground.
If there is continuity when the transmission is in neutral
or when the clutch lever is squeezed, the ground circuit
is normal.
POWER INPUT LINE
Connect the starter relay switch 4P (Red) connector [1].
Turn the ignition switch to "ON".
Measure the voltage between the Yellow/red wire
terminal (+) and ground (–).
If the battery voltage appears only when the starter
switch is pressed, the circuit is normal.
[1] [2]
[3]
[4]
[5]
[1]
[1]
[1]