Honda WMP20XE1T, Руководство пользователя

Страница: 6 / 100

6
ENGLISH
APPROVED LIQUIDS
The following is a list of chemicals that the multi-purpose pump is
capable of pumping. The operator
must verify that the liquid that is to
be pumped is on these lists. After each use, drain the pump chamber
into a suitable container and flush with fresh water.
Do not use for pumping liquids for human consumption.
Do not use for pumping flammable liquids.
NOTICE
Pumping liquids that are not listed may cause damage to the pump.
Agricultural Chemicals
Industrial Chemicals
PUMP PERFORMANCE
The maximum pump discharge capacity is determined when pumping
clear water at 0 meters total head and at sea level. As the total head
[1] (discharge head [2] + suction head [3]) increases, pump discharge
capacity decreases (see figure). If the pump is used at higher
elevations, pump discharge capacity may also decrease. Other
factors affecting pump discharge capacity are:
• The type of chemical being pumped.
• The length and type of the suction and discharge hose used.
Oil Alert® System
The Oil Alert system is designed to prevent engine damage caused by
an insufficient amount of oil in the crankcase. Before the oil level in
the crankcase can fall below a safe limit, the Oil Alert system will
automatically shut down the engine (the ignition switch will remain in
the ON position).
If the engine stops and will not restart, check the oil level (page 9)
before troubleshooting in other areas.
 WARNING
Chemicals can cause burns or serious injury.
Wear protective clothing and eye protection when handling
chemicals.
Follow the chemical manufacturer’s handling procedures.
Aatrex Eradicane Poly-N
Amiben Extrazine Ranger
Ammonium
Thiosulfate Larsban Round-up
Banvel Lasso Sutan
Basagran URAN Solutions Treflan
Bicep Modown Vernam
Bladex N-Serve 24
Dual Phosphoric Acid
Solutions
Acetic Acid, 20% Lactic Acid Sodium Bisulfate
Aluminum Sulfate Lead Acetate Sodium Bisulfite
Ammonium Nitrate Magnesium Chloride Sodium Carbonate,
10%
Ammonium Sulfate Magnesium Nitrate Sodium Chlorate
Barium Sulfate Magnesium Sulfate Sodium Chloride
Borax (Sodium
Borate) Maleic Acid Sodium Nitrate
* Calcium Chloride Nickel Chloride Sodium Silicate
Citric Acid Nickel Sulfate Sodium Sulfate
Copper Sulfate Oleic Acid Stearic Acid
Detergents
(General) Phosphoric Acid,
0-80% Sulfuric Acid, 0-29%
Ethylene Glycol Potassium
Carbonate Tartaric Acid
Fatty Acids Potassium Chloride Vinegar
Ferric Nitrate Potassium Nitrate Water (Clear)
Ferric Sulfate Potassium Sulfate Water (Salt)
Ferrous Sulfate Soaps (neutral) Zinc Sulfate
Formaldehyde, 40% Sodium Acetate
Glycerine (Glycerol) Sodium Bicarbonate
* Temperature does not exceed 26°C.
The temperature operating range of the pump is between
-7 ~ 54°C.
Pump Performance (maximum with clear water)
Total head [1] 31 m
Suction head [3] 9.5 m
Discharge capacity 850

/min
Self-priming time 47 sec at 5 m
Pressure 300 kPa
[2]
[3]
[1]