HoMedics HST-200-EU, Руководство пользователя

Страница: 4 / 40

GB I 4
MAINTENANCE:
Cleaning
Unplug the appliance and allow to cool before cleaning. Clean only with a
soft, slightly damp sponge.
•
Never allow water or any other liquids to come into contact with the
appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint
thinner etc to clean.
Storage
Place the appliance in its box or in a safe, dry, cool place. Avoid contact
with sharp edges or pointed objects which might cut or puncture the fabric
surface. To avoid breakage, DO NOT wrap the power cord around the
appliance. DO NOT hang the unit by the cord.
WEEE explanation
This marking indicates that this product should not be disposed
with other household wastes throughout the EU. To prevent
possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmental safe
recycling.
Battery Directive
This symbol indicates that batteries must not be disposed of in the
domestic waste as they contain substances which can be damaging
to the environment and health. Please dispose of batteries in designated
collection points. When the product reaches the end of its life, please
remove the batteries from the product and dispose of them as directed
above.
Problem Possible Cause Solution
NO DISPLAY SHOWN. - Battery not installed
- Battery installed incorrectly
- Battery is dead
- Install Battery
- Check polarity of the battery is it in right
position
- Replace battery
WITH DISPLAY BUT NO FUNCTION. - No skin contact
- Unit not snapped on gel pad correctly
- Intensity level at 0
- Microprocessor hang up
- Battery is low
- Use water based gel on conductive area and
place pad directly onto skin
- Check that unit is connected firmly with both
connectors to the pad
- Push ON/HI button to increase intensity
- Reset by removing battery for 1 minute, re-
insert battery
- Change battery
LCD DISPLAY IN NORMAL BUT NOTHING
OCCURS. - Intensity set to low level
- Not enough conductive gel on pad
- Used gel is not water-based
- Pad is worn or has oil deposits
- Battery is low
- Push ON/HI button several times to increase
intensity
- Put more water based gel between pad and
skin
- Read label on the gel that you use. Make sure
you find “water” or “aqua” on it.
- Clean pad or replace (see Hint below)
- Change Battery
ALL BUTTONS DO NOT WORK WELL. - Microprocessor hang up
- Battery is low
- Reset by removing battery for 1 minute, re-
insert.
- Change battery
TROUBLESHOOTING
IB-HST200EU-1117-06.qxp_Layout 1 09/11/2017 15:09 Page 4