HOMCOM A90-194, Инструкция по сборке

Страница: 9 / 12

9
1. You will need 2AAA batteries (provided) to operate the Computer.
2. To select the function you want, press the MODE button and then select the function of choice from
the table above.
3. To reset the Computer, hold down the MODE button for 5 seconds.
4. The Computer will automatically turn off after 4 minutes when the bike is not in use. Press any key to
restart.
5. To adjust the resistance, turn the tension control to the right (harder), or to the left (easier) .
6. If there is an improper display on the Computer, please replace both batteries with new ones at the
same time.
7. To move the bike, hold onto the saddle support pole, lift and push forward.
MAINTENANCE
Regular maintenance will prolong the life of your spin bike and prevent injury. We strongly recommend
that you do the following on a regular basis:
1. Clean the bike after use with a soft cloth
– ensure it is dry. Note, a build up of moisture over time will
cause corrosion.
2. Clean the Computer display with a soft cloth and anti-static computer spray to remove dust or finger
prints. Note , harsh chemicals will destroy the protective coating on the Computer and cause a static
build up inside the Computer that could damage the components.
3. Check the front and back stabilizers each time you use the bike to ensure the bike is stable and level
with the floor.
4. Check and tighten loose nuts/buts, the saddle adjustment locks, pedals, and handlebars to ensure
they are secure each time you use the bike to avoid injury.
5. A spent battery is hazardous waste, please dispose of it correctly, and do not throw it in the trash.
6. For replacement parts, contact the distributor.