Holzstar 5904150, Руководство по эксплуатации

Страница: 16 / 22

16 BTS-Series | Version 3.06
Troubleshooting
13 Troubleshooting
14 Disposal instructions / recy-
cling facilities
Dispose of your device in an environmentally friendly, by not
disposing of waste in the environment but professio-nally.
Please take the packaging and later the old appliance
does not just go away, but discard them in accordance
with the relevant of your city / municipality or by the wa-
ste disposal company established guidelines.
14.1 Decommission
Discarded appliances are immediately professionally de-
commission, in order to avoid any later misuse and the
threat to the environment or people.
Step 1: Remove all environmentally hazardous materi-
als from the old device.
Step 2: Remove the machine optionally into manage-
able and actionable assemblies and compo-
nents.
Step 3: Leading the machine components and supplies
the appropriate disposal routes.
14.2 Disposal of new equipment
packaging
All used packaging materials and packaging aids of the
machine are recyclable and must always be recycled.
The packaging wood can be sent for disposal or recy-
cling.
Packaging components made of cardboard can be crus-
hed for waste paper collection.
The foils are made of polyethylene (PE) or the upholstery
parts made of polystyrene (PS). These substances can
be reused after processing if they are passed on to a
recycling center or to the disposal company responsible
for them.
Only pass on the packaging material in such a way that it
can be directly recycled.
Fault Possible causes Disposal
Engine is not running Damaged ON / OFF switch
Damaged ON / OFF switch lead
Relay damaged
Engine defective
Fuses defective
Have the machine checked by an electri-
cian and replace the damaged parts
Machine slows down while
working It is worked with too much pressure Apply less pressure on the workpiece
Low service life of the abra-
sives Abrasive (tape or disk) with too fine grain Use a grinding wheel with coarse grain
Grinding angle does not fit Adjusted angles on the work table or on
the stop bracket do not fit Check angle and adjust if necessary
Bad sanding picture Abrasive with too coarse grain Use finer grained abrasive
Grinding wheel runs opti-
cally out of round Sanding belt not laid correctly Trace the track of the sanding belt
Grinding wheel runs off the
drive pulleys Sanding belt not laid correctly Trace the track of the sanding belt
Wood burns during grinding Grinding sleeve or abrasive belt is coated
with lubricant. There is too much pres-
sure on the workpiece Replace the sanding sleeve or sanding
belt. Reduce the pressure on the work-
piece.