Holzmann FS 200SF, Руководство пользователя

Страница: 14 / 44

www.holzmann-maschinen.at
4. OPERATION
>> Place the safeguard over the threa-
ded holes onto the table.
See Fig. C:
>> Install the ratchet lever (r) M8x150
with a 8mm large washer into the safe-
guard (s) and thread the ratchet lever
clockwise to secure the table.
>> Slide the fence (f) onto the fence car-
riage and secure it.
>> See Fig. D: To align the fence, adjust
both fences so that they are in perfect
alignment, control the alignment with a
straightedge.
>> See. Fig. E: Insert the feeder arm
into the feeder base and secure it with a
startype screw M8x25.
>> Place the feeder Assy (f)and the Anti
kickback assembly (k) and secure it.
This machine is operated indoors and has
to be connected to a dust collection sys-
tem of a suitable capacity:
The dust collection system has to have
a minimum air flow rate of 20 meters/
second.
Connection should be realized with a fle-
xible suction hose with 100mm diame-
ter.
The distance machine - dust collecting
system should not exceed 10 meters.
The motor is equipped with a thermal pro-
tection system, and will be automatically
switched off in the case of overload.
The motor can be switched on again after
a cooling down period that can vary.
Electric checks and the electric installa-
tion of the machine may only be perfor-
med by a qualified electrician.
Electrical connection cables must comply
with the regulations applicable in your
country.
INSTALLING THE SAFEGUARD
INSTALLING THE FEEDER ASSY
Read the manual before assembly and
operation. Become familiar with the
machine and its components before
beginning any work. Serious personal
injury may result if safety or operati-
onal information in not understood or
followed.
CAUTION
!
This machine is equipped with a V-belt
drive system that controls the speeds.
To change spindle speed follow these
steps:
>> Unplug the machine from the
power connection.
See Fig. F:
>> Loosen the two startype screws
M6x30, open the Machine housing
door.
>> Loosen the Allen Bolt M12x40 (a)
with an allen wrench, pull the
motor tension lever (b) out.
See Fig. G:
>> Select the desired speed. Fig. G
shows the belt positions for each
available speed.
>> Align the belt along the apropriate
pulley grooves.
>> Push up the motor tension lever (b)
and tighten the Allen bolt (a).
>> Tighten all the adjusting bolts.
>> Spin the pulley by hand to ensure
proper tracking.
>> Close the machine housing door.
>> For belt change follow principally
the same procedure as described
above!
SPEED CHANGES
IMPORTANT
!
Shut the machine off with the red but-
ton of the main switch and wait until
the spindle rotation has stopped entire-
ly before performing any adjustments
or setups.
For some setups you need to unplug the
machine additionally to avoid the dan-
ger of unintentional machine start up.
CONNECTING TO DUST COLLECTION
ELECTRIC CONNECTION
ENGLISH