HOLZMANN MASCHINEN NTS 200FLEX, Руководство по эксплуатации

Страница: 23 / 30

TROUBLESHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 23
NTS200FLEX
14.3 Dressing grinding wheel
Depending on the type of grinding you do, the grinding wheel may require periodic dressing.
NOTICE: If the diameter of the grinding wheel will be smaller the set angle with the
angle guide will be different!
A dressing tool of HOLZMANN-MASCHINEN can be used to restore the abrasive wheel edge back to
a square form quality of the wheel surface and bring the wheel edge back to a square form
.
14.4 Storage
N O T I C E
Improper storage can damage and destroy important components. Only store packed
or unpacked parts under the intended ambient conditions!
When not in use, store the machine in a dry, frost-proof and lockable place to prevent the
formation of rust on the one hand and to ensure that unauthorised persons and in particular
children have no access to the machine on the other hand.
14.5 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options
available.
If you buy a new machine or an equivalent device from your specialist dealer,
he is obliged in certain countries to dispose of your old machine properly.
TROUBLESHOOTING
W A R N I N G
Danger due to electrical voltage! Manipulating the machine with the power supply
up can lead to serious injuries or death. Always disconnect the machine from the
power supply before carrying out any troubleshooting work!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains.
If you are unable to carry out necessary repairs properly and/or do not have the required
training, always consult a specialist to correct/solve the problem!
Trouble Possible cause Solution
The magnetic support has no
magnetic force

ON/OFF-switch damaged

Saw unplugged

Fuse blown or circuit breaker
tripped

Cord damaged

Check the switch

Check all power connections

Change fuse or reset circuit
breaker

Change cable
Machine slows down during
working

Exerting too much pressure to
the sanding abrasive

Exert less pressure on the work
piece
Bad sharpening result

Wrong angle set

Check the set angle and set new
if it is necessary
Sanding disc runs out of round

Grinding wheel is worn

Dress grinding wheel