HOLZMANN MASCHINEN KAP305ECO, Руководство пользователя

Страница: 34 / 45

CLEANING, MAINTENANCE, STORAGE, DISPOSAL
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 34
KAP 305ECO
17.2.4 Setting the Laser
If the laser (17) does not show the correct cutting
line any more, you can adjust the laser. Loosen the
Phillips screws (S) and adjust the laser by moving it
sideways until the laser beam hits the teeth of the
saw blade. Tighten both screws (S) again.
17.2.5 Emptying/changing the chip bag
The saw is equipped with a sawdust and chip
collection bag.
Attention! The sawdust/chip bag may only be used
for cutting wood and wood-like materials!
Press the metal ring on the sawdust/chip bag (1)
together and fasten it to the dust outlet. The chip bag
can be emptied by means of a zipper.
17.2.6 Check / change carbon brushes
Check the carbon brushes after the first 50 hours of
operation with a new machine or when new brushes are
fitted. After carrying out the first check, repeat the check
every 10 hours of operation.
If the carbon is worn down to a length of 6 mm, or if the
spring or contact wire is burnt or damaged, it is
necessary to replace both brushes. If it turns out that the
brushes can be used after removal, it is possible to
remount them.
When servicing the carbon brushes, open the two locks
counterclockwise. Then remove the carbon brushes.
Replace the carbon brushes in reverse order.
17.2.7 Exchange table insert
C A U T I O N
If the table insert (1) is damaged, there is a risk that small parts may become stucked
between the table insert and the saw blade and block the saw blade
1. Remove screws (S) from the table insert (1). If
necessary, turn the rotary table and machine head to
reach the screws.
2. remove the table insert (1).
3 Install the new table insert (1).
4 Tighten the screws (S) on the table insert (1).