HOLZMANN MASCHINEN KAP305ECO, Руководство пользователя

Страница: 29 / 45

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 29
KAP 305ECO
16.2.4 Setting the stops/fences
The two adjustable stops (1 and 2) must be adjusted after
changing the machine head angle. To do this, loosen the
fixing screws (1 and 2a) and adjust the fences so that
there is a gap of at least 5 mm between the saw blade and
fence. Then retighten the fixing screws to fix the stops.
C A U T I O N
Before cutting, check that the stop bars and
the saw blade cannot collide. (simulated cut
with switch-off machine)
16.2.5 Setting cutting depth / cutting depth limiting
The cutting depth can be adjusted continuously with the
screw (2a). To do this, loosen the thumb nut (2) on the
screw (2a). Turn the screw (2a) in or out to set the desired
cutting depth. Then retighten the thumb nut (2).
The lowest cutting depth limit is adjusted by means of screw
1. To do this, loosen the nut (1a) and screw in the screw for
a deeper cutting position, screw out the screw for a higher
cutting position and then fix it again by tightening the nut
(1a).
N O T I C E
Check the setting by performing a test cut.
16.2.6 Setting the workpiece support
The workpiece support (1,2) can be adjusted in its position
in relation to the table. To do this, loosen the screw (1a,
2a), pull out the workpiece support or move it to the rotary
table and then fix it in the required position by tightening
the screw (1a, 2a).
16.2.7 Connection to a dust collection system
For dust extraction in closed rooms, connect a suction hose to the dust extraction nozzle and fix it
with a hose clamp. Connection dimensions according to technical data.