HOLZMANN MASCHINEN K5 315VF-2000, Руководство пользователя

Страница: 46 / 94

ASSEMBLY
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 46
5-fach Kombination / combined 5-operation machine K5 315VF-2000
13.2.4 Control
After connection to the power grid, it is necessary to check the direction of the saw blade. To
start the engine briefly. If the blade rotates in the wrong direction, you have to fix the direction of
two cord ends.
13.3 Earthing connection
A T T E N T I O N
When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore:

Machine must be grounded and be connected to a grounded outlet
 The electrical connection of the machine is ready for operation on a grounded electrical outlet!
 The plug must be connected only to a properly fitted and grounded electrical outlet!
 The supplied plug must not be changed. If the plug does not fit or is defective, only a qualified
electrical engineer may modify or replace these plugs!
 The grounding conductor is green-yellow!
 In the event of repair or replacement of the grounding conductor must not be connected to an
under voltage can!
 Check with a qualified electrician or service that the grounding instructions are understood and
the machine is grounded!

A damaged cable must be replaced immediately!
13.3.1 Extension cable
Make sure that the extension cord is in good condition and suitable for the transmission of power.
An undersized cord reduces the transmission of power and heats up. The following table shows
the correct size depending on power and length.
13.4 Adjustment before initial

Before any adjustments, the machine must be disconnected from the power supply to avoid
the risk of accidental switching on the machine!

Check that the set speed for the saw blade used is not too high.

Span only saw blades with a diameter of 254-315 mm.
13.4.1 Assembly / Disassembly of the saw blade and scoring unit

Adjust the cutting height to the greatest degree.

Move the sliding table all the way forward. Open by
removing the screws M6x12 the safety cover.

With a 12mm Allen key you back up the shaft from
turning and unscrew the flange nut.

The saw blade can be installed or removed and insert-
ed a new one. Installation is in the reverse order of
removal.

The scoring blade is mounted with a wrench and also
dismantled.