HOLZMANN MASCHINEN K5 315VF-2000, Руководство пользователя

Страница: 39 / 94

SAFETY
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 39
5-fach Kombination / combined 5-operation machine K5 315VF-2000
 On the device are only few of them serviceable components. It is not necessary to
dismantle the machine. Repairs must only be performed by an expert!
 Accessories:
Use only recommended accessories HOLZMANN !
 If you have any questions or problems, contact our customer service.
12.4 Safety devices
In the design of the machine following protective devices are provided:

Restraint of the gap wedge. This measure is intended to prevent the return of the workpiece,
and the setting is in horizontal and vertical direction relative to the saw blade.

Blade guard:

The cap is mounted on the gap wedge to avoid contact with the blade.

The blade unit can be submerged entirely under the workbench. This you have to remove the
cover from the gap wedge.

Device for locking the setting selected in the vertical and horizontal direction and in an inclined
position.

Flanges for fastening tool. They are secured by a key on the shaft to the loosening of the tools
to avoid the stop of the machine.

Nut (left-hand thread!) For mounting on the tool shaft. wells for Adjusting the scorer.

Rip fence. Is used for precise guiding of the workpiece in the longitudinal cutting. He is also
made of destructible material (aluminum).

The setting of the parallel ruler is possible without the use of tools, and the position is read on
a graduated scale.

Switch. While the belt is changed, with the door open, the engine will not start.

Electronic brake for electrodynamic braking of the motor. Secures the tool brakes in less than
10 seconds after the drive off.

Impeccable sharpened tools.

The use of blunt tools is not permissible due to kickback, overloading the machine and produce
poor surface during processing.

Red wire support. For cutting operation where less than 120mm are cut off, less than 120mm
distance right of the blade to the rip fence. Here the wood by hand carry, but with the red wire
support.
12.5 Residual risk factors
Also in compliance with all safety regulations and when used following residual risks are considered:

Risk of injury to the hands / fingers through the circular saw blade during operation.

Risk of injury from contact with live electrical components.

Risk of injury or ejection fraction or the circular saw blade circular saw blade parts, especially
case of overload and in the wrong direction.

Hearing, unless arrangements have been made by the user for hearing protection.

Risk of injury from kickback of the cuttings, the ejection of the cut material or parts of there.

Risk of injury to the eye by flying debris, even with goggles.

Risk due to inhalation of toxic dust in chemically treated wood Workpieces.