Holder A-Trac 5.58 P, Руководство по эксплуатации

Страница: 88 / 190

A 5.58 / A 5.58 P
Operating Instructions
86
145 146
Operating the Implements
Installing the Cardan Shafts
Only use shafts suitable and intended for the implement.
These shafts are supplied with the implement. The length of
the articulated shaft must adjusted before the first installa-
tion. In case of doubt, please contact our customer service.
Observe installation instructions for the articulated shaft
when installing it.
DANGER
Shut off the engine before the installation. Fit
the protective devices as specified after in-
stallation. After the removal, cover the PTO
shaft (1) again with the protective cap.
Removing Implements
- Drive the implement to its storage place and lower it
with the lift.
- Stop the engine, but do not turn off the ignition.
- Operate all control levers for the lift several times in
all directions. This will relieve the pressure in the
hydraulic system.
- Slide the outer ring of the hydraulic couplings (1) back
and disconnect the hydraulic hoses.
- Close the protective caps on the hydraulic couplings.
1
2
3
Bild_064
- Remove the upper link from the pin of the upper link
support.
- Pull the quick attaches (3) up to release the imple-
ment pins.
- Lower the lift and drive forward carefully.