HOKKIM HAMF-4, Руководство пользователя, Страница: 6 / 15

6) GRR - G enerator R un R elay
ON (green) LED On - Generator output voltage is stable. Relay energized.
7) CCR - C rank C utout R elay
ON (Green) LED On - Crank cutout relay energized.
8) OPT - O il P ressure T imer
ON (green) LED On - Generator voltage stable and oil pressure timer activated.
UP (amber) LED On - Timer relay energized and oil pressure delay contacts closed.
Time Adjustment - 0 to 20 Sec.
9) ASR - A ttempt S tart R elay
CRANK (amber) LED On - Crank relay energized and output to external start relay.
Time Adjustment
- 0 to 20 Sec.
REST (green) LED On - Crank relay de-energized, no output to external start relay.
Time Adjustment
- 0 to 20 Sec.
FAIL (red) LED On - Fail to start relay energized and output to fault alarm relay.
Selection - 1 to 9 attempt.
10) BCR - B ell C ancel R elay
CANCEL (green) LED On - Bell cancel push-button pressed (close). Bell silenced.
BELL (amber) LED On - Bell relay energized and output to external bell.
11) LFR - L amp F lashing R elay
Flashes on-off the lamp output relay in the Fault Alarm Relay card.
Adjustment - Flashing rate from slow to fast and steady
.
12)
FAR - F ault A larm R elay
LAMP (amber) LED On - Lamp relay energized and output to external lamp.
ALARM (red) LED On- Fault signal detected and alarm activated.
Selection
- Loop to next FAR or Out to FMR.
13) OPR - O il P ressure R elay
Provides 4 nos. delay-on contacts, set by OPT, for fault alarm signals.
14) MFT-V - M ains F ail T imer - V aristor
Contains metal oxide varistors to absorb voltage surge, above 56VDC, at terminals T11 & T12.
15) MAMF - AMF M otherboard
Base printed circuit board for HAMF-8/4.
TERMINALS IDENTIFICATION
Now we will look at Figure 5 to identify the connection terminals located on the base PCB. These
terminal connections shows you how to wired up the Integrated AMF to external relays, push buttons,
selector switch, bell, fault signal input, etc. to complete the control board.
For easier identification, the terminals are broken into 5 sections, they are; T01 to T32, L1 to L8, S1 to
S8, 11 to 44 and lastly, C1 to C8. A detailed description is given below:
Page 6
HOKKIM
giving you control
Control & Protection Relays