Hoffmann MORSO NFXL, Руководство по эксплуатации

Страница: 26 / 50

25
Instruction Manual
MORSØ Notch Cutting Machine
Model NFX
Adjustment of Height Stop (17)
The height stop (17) is used for adjustment of the knife block (5) to a suitable height
compared to the moulding to be cut.
In this way you avoid unnecessary high foot movements.
The moulding is placed on the table (the knife block must be in the rear position, as shown
on the picture). The knife block (5) is moved forward to the front position by means of handle
(22).
With the foot pedal (12) the knife block (5) is moved down to the height required, approx.
min. 20 mm above the moulding.
The height stop (17) is loosened and moved. Fasten the height stop against the foot pedal
lever (13).
The height stop is also used for locking the knife block in the bottom position when the
machine is not in use.
Operating Instructions G-6