Hoffmann MORSO NFXL, Руководство по эксплуатации

Страница: 14 / 50

13
Instruction Manual
MORSØ Notch Cutting Machine
Model NFX
In General
The machine is delivered ready for use and complete with standard equipment.
Only the table extensions (18) and fences (8) are dismounted during transport.
NOTE before starting up first time:
1. The lever clamp on the arc is loosened (it functions as the rear stop when moving the
knife block backwards).
2. The knife block is moved halfway back, and the waste chute is fitted.
Place the machine 1 m from the wall as stated in D-1. The machine can be fastened to the
floor using parabolts through the two holes in the bottom of the machine frame.
Check each time before starting that all protection devices are correctly fitted.
Fitting the Table Extensions and fences
(the drawing shows the left side, the same procedure is used on the right side).
Before fitting, the ends of the table extension (18) and the table (7) must be cleaned
thoroughly. Special attention must be paid to the pin and screw holes, as the smallest
amount of dirt will prevent the correct alignment.
After cleaning, the table extension is pressed against the table so that the pins placed in the
table extension are inserted in the pin holes in the table. The included bolt is now inserted
into the hole and fastened with a standard spanner.
The fence (8) is fitted on the table extension (location pins are fitted in the table extension). It
is secured with allen screws.
(Extra extension tables and supporting legs can be ordered as accessories).
Assembly Instructions F-1