Hoffmann MORSO NFXL, Руководство по эксплуатации

Страница: 20 / 50

19
Instruction Manual
MORSØ Notch Cutting Machine
Model NFX
Adjustment of the cock-bead stops (10)
The cock-bead stops (10) are adjusted as follows:
1. Loosen the Allen screws on the cock-bead stops (10) and move these to rear of the
sliding guide.
2. Using a test piece (a) make a notch cut into the cock-bead. This cut must be the same
depth as the cock-bead. The overall width must be equal to the width of the centre cross-
rail. When you are satisfied the two sizes are equal, we can now position and lock the
cock-bead stops (10).
3. Press the foot-pedal down and hold it in this position. By operating the hand lever, bring
the knife block (5) forward into the previously cut notch. Position the cock-bead stops (10)
against the cock-bead and lock them in place using the Allen screws. When these stops
are fixed in position the knife block (5) can only cut into the cock-bead as far as this
setting. The notch cut depth is then referenced from the face of the cock-bead. The width
of stile can vary without changing this setting.
4. Check the alignment of the two cock-bead stops (10) using a straight edge. By bringing
the knife block (5) forward, check that they are level and true with the fence.
5. Lock the second Allen screws on the cock-bead stops (10).
6. This setting will allow you to make regularly accurate notch cuts in the stiles. These stops
will need no further adjustment unless the size of the cock-bead changes.
Operating Instructions G-3