• Insert and glue ribs F15 - F21 at the predetermined positions on the panels F5 / F6 and to the web spar F10.
• Attach the connecting ribs F14 to the sheeting F5 / F6 and to the spar F10.
Caution
: The ribs F14 must sit against the angle of the spar F10.
The angle of the spar is what creates the V-shape of the wing.
• Insert the leading edge F22 into the recesses of the ribs for the center panel.
If the leading edge lines up well with the ribs and the sheeting then glue in place.
• Insert the leading edge F23 into the recesses of the ribs for the outer surface parts.
If the leading edge lines up well with the ribs and the sheeting then glue in place.
• Plane or sand the leading edge following the profile. See also section D and E.
While sanding,
be careful not to damage the ribs
. (Tip, use tape to mask ribs)
In
no
va
tio
n
As
se
m
bl
y
M
an
ua
l (
EN
) V
9
