• Screw the motor to the motor bulkhead R33 using the enclosed screws. Wrap the motor in paper/ or tape so that
it fits snugly into the nosepiece. This will ensure that the motor is centered and that the motor will turn freely after
gluing the bulkhead.
• Apply a small amount of glue to the motor bulkhead.
• Insert the motor with the wires into the nose block R14. The motor wires must be in the provided groove.
Tack
the components with small amount of glue. Clamp or use tape until they cure.
Remove the motor (and tape/paper) and glue the motor bulkhead securely with a thin CA to the entire
circumference. Allow the adhesive to cure.
Caution
: The adhesive penetrates the wood grain and hardens the nose block.
• Glue the nose block R14 to the fuselage and secure with clamps.
• Align the fuselage directly on the top of the plan and glue R13 together.
Caution
: Make sure that the boom is straight.
• Glue R12 at the marked location.
Note
: The holes are located towards bottom (see section C)
In
no
va
tio
n
As
se
m
bl
y
M
an
ua
l (
EN
) V
9
